Low profile Redi-Rail 34 mm x 500 mm, aluminum with hardened steel raceways; pairs with RRL34C-A2.
COMPONENT
Pre-drilled low profile support rail, 12 in, for 5/8 in shafts; AISI C-1018 steel, 40% lower profile.
Low profile steel support rail, 12 in, for 1/2 in shafts; 40% lower profile, AISI C-1018 steel.
1/2 Inch Diameter Carbon steel linear shaft, precision case hardened and ground, fused to a low profile AISI C-1018 Steel Linear Support Rail. This Low Profile Linear Support Rail Assembly (LSRA) is 40% lower than regular assemblies. Length: 12" Not Drilled If standard mounting holes are required on the support rail, specify this via Configure CAD & Quote below using the part number LSR-12-PD which will get you standard industry hole spacing (you can also submit drawings for
Low profile linear slide rail, 17mm wide, 6mm high and 100mm long, for Mini-Rail miniature linear guides, compatible with LPM17C carriages. Anodized aluminum construction with Gliding Surface Technology™ (GST) provides maintenance-free, low-friction linear motion with ≤0.5mm running clearance.
SPINEA (Slovakia, a Timken company) DriveSpin DSF is the flat low-profile variant of the DriveSpin family, integrating a zero-backlash Twin Spin cycloidal gear with a servo motor into a compact actuator with extremely short axial length; three frames DSF 050/070/095 with 12-85 Nm rated output torque (DSF 070: 50 Nm rated, 100 Nm acceleration/braking), ratios 57/75, 2,000 rpm rated input. The built-in bearing system gives high torsional stiffness and load capacity; low mass and small size suit robot joints, AGVs and medical devices with tight height constraints.
